1997 Ford F-250/350/Super Duty Engine Front Cover Removal
download Crankshaft front seal replacement is recommended whenever the engine front cover (6019) has been removed. 1. Disconnect battery ground cable (14301). Drain crankcase. 2. Drain cooling system....
View Article1996 Nissan Altima GLE TIMING CHAIN Removal
download 1. Release fuel pressure. See FUEL PRESSURE RELEASE . Drain coolant from radiator and cylinder block. Drain engine oil. Disconnect all necessary coolant hoses, electrical connectors, vacuum...
View Article1998 Nissan Sentra TIMING CHAIN Removal
download CAUTION: If camshaft or crankshaft is rotated with timing chain disconnected, piston will contact valves, resulting in bent valves. NOTE: For reassembly reference, apply paint marks to timing...
View Article1997 Cadillac Catera Drive Axles, Bearings and Joints: Rear Suspension...
download 1. Raise and support the vehicle. 2. Remove the tire and wheel assembly. 3. Use the J 42066 and use a 1/2 inch breaker bar to counter hold the rear wheel hub. Important: DO NOT allow the drive...
View Article2006 Honda Civic Rear ABS Wheel Speed Sensor and O-Ring Inspection
download During assembly, some wheel speed sensors may have been improperly installed and do not seal the hub assembly. Water may enter the hub assembly and damage the wheel bearing. In areas where...
View Article2001 Toyota Sienna CE Trunk / Liftgate Service and Repair DISASSEMBLY
download 1. REMOVE BACK DOOR ASSIST GRIP a. Using a screwdriver, open the covers. HINT: Tape the screwdriver tip before use. b. Remove the 2 screws and assist grip. 2. REMOVE BACK DOOR PULL STRAP a....
View Article2004 Ford F-150 Rear Axle Differential Cover Axle Shaft Oil Seal and Rear...
download 1. With the vehicle in NEUTRAL, position on a hoist. For additional information, refer to Section 100-00. 2. Remove the rear wheel and tire assembly. For additional information, refer to...
View Article1995 Ford Thunderbird Spring REMOVAL AND INSTALLATION
download Removal 1. Raise vehicle on hoist. Refer to Section 00-02. 2. Remove rear wheel and tire assembly. 3. Remove rear stabilizer bar link and bushing link nuts at both ends of rear stabilizer bar...
View Article1994 Ford Mustang A/C Evaporator Housing Removal and Installation
download 1. Disconnect battery ground cable (14301) . 2. Remove two console armrest mounting access covers (047A62) at rear of console panel (045A36) (snaps out) to gain access to armrest retaining...
View Article1993 Mitsubishi Montero TRANSFER CASE DISASSEMBLY
download Disassembly (Ram-50) 1) Remove both 4WD indicator switches and steel balls. Remove speedometer gear assembly. Remove output shaft cover, gasket, wave spring and spacer. See Fig. 3. Remove rear...
View Article
More Pages to Explore .....